Home of the official* MG3, MG6, MG GS & MG ZS forum Forum Index Home of the official* MG3, MG6, MG GS & MG ZS forum

"The most refreshing forum in the galaxy" — Paul Stowe
"The forum the AROnline forum could have been" — Keith Adams
"Very committed subhumans" — NickTL

REMEMBERING OUR FRIEND "DROITWICH LLOYD" RIP
 
 HomeHome   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 


The soap opera that is my R17 Coupe.
Goto page Previous  1, 2, 3  Next
 
Post new topic   Reply to topic    Home of the official* MG3, MG6, MG GS & MG ZS forum Forum Index -> Readers’ drives
View previous topic :: View next topic  
Author Message
Giles
DOING IT AGAIN FOR FUN AND PROFIT


Joined: 07 Nov 2018
Posts: 331

PostPosted: Mon Jan 21, 2019 8:57 am    Post subject: Reply with quote

After the disaster trying to replace this, I better give a status update.

1) A wheel bearing is making an unpleasant noise, but not yet loud enough to locate.
2) There is a small blow on the exhaust manifold gasket.
3) The lower door cladding has fallen off the passenger side and I can't source any clips to refit it.
3a) The drivers door cladding is starting to go too.
4) I decided to give it a damn good clean and managed to knock the high level brake light off the rear screen.

Remind me, how much are MG6s making at the moment...?
Back to top
View user's profile Send private message
Seamaster
A HEATHEN, CONCEIVABLY


Joined: 11 Nov 2018
Posts: 1337
Location: Summerisle

PostPosted: Mon Jan 21, 2019 8:59 am    Post subject: Reply with quote

Giles wrote:
Remind me, how much are MG6s making at the moment...?


Too good for you, Giles.
Back to top
View user's profile Send private message
620bob
HORMONAL REMAINIAC


Joined: 08 Nov 2018
Posts: 1126
Location: Bobniston

PostPosted: Mon Jan 21, 2019 9:10 am    Post subject: Reply with quote

Giles wrote:
After the disaster trying to replace this, I better give a status update.

1) A wheel bearing is making an unpleasant noise, but not yet loud enough to locate.
2) There is a small blow on the exhaust manifold gasket.
3) The lower door cladding has fallen off the passenger side and I can't source any clips to refit it.
3a) The drivers door cladding is starting to go too.
4) I decided to give it a damn good clean and managed to knock the high level brake light off the rear screen.

Remind me, how much are MG6s making at the moment...?


This car HATES you
Back to top
View user's profile Send private message
Shergar
ELTHICK


Joined: 08 Nov 2018
Posts: 181

PostPosted: Wed Jan 23, 2019 10:11 pm    Post subject: Reply with quote

I think we have the star of the Christine remake.
_________________
He rode me and left me for dead.
Back to top
View user's profile Send private message
Giles
DOING IT AGAIN FOR FUN AND PROFIT


Joined: 07 Nov 2018
Posts: 331

PostPosted: Wed Mar 13, 2019 11:02 pm    Post subject: Reply with quote

Anyone got an YRC100250?

EU subsidy cheque cashed and waiting.....
Back to top
View user's profile Send private message
Lord Sward
SWARDUS ET PKLESS


Joined: 08 Nov 2018
Posts: 839

PostPosted: Wed Mar 13, 2019 11:16 pm    Post subject: Reply with quote

Blipper?
Back to top
View user's profile Send private message
Barry
A BUNCH OF SPASTIC


Joined: 07 Nov 2018
Posts: 727

PostPosted: Wed Mar 13, 2019 11:19 pm    Post subject: Reply with quote

Can't you just buy an Avensis and get on with life.
Back to top
View user's profile Send private message
5ivegearsinreverse
ROBERT JEKYLL & GORDON HYDE


Joined: 07 Nov 2018
Posts: 499
Location: Soke of Retardnumberplateshire

PostPosted: Wed Mar 13, 2019 11:30 pm    Post subject: Reply with quote

Barry wrote:
Can't you just buy an Avensis and get on with life.


Or a Fendt or Laverda.

Oh hold on. AGCO shite...
Back to top
View user's profile Send private message
Barry
A BUNCH OF SPASTIC


Joined: 07 Nov 2018
Posts: 727

PostPosted: Wed Mar 13, 2019 11:31 pm    Post subject: Reply with quote

5ivegearsinreverse wrote:
Barry wrote:
Can't you just buy an Avensis and get on with life.


Or a Fendt or Laverda.

Oh hold on. AGCO shite...

A Fendt is too good for him, he'd be better of with a 20 year old Landini.
Back to top
View user's profile Send private message
5ivegearsinreverse
ROBERT JEKYLL & GORDON HYDE


Joined: 07 Nov 2018
Posts: 499
Location: Soke of Retardnumberplateshire

PostPosted: Wed Mar 13, 2019 11:35 pm    Post subject: Reply with quote

Solis, more like.
Back to top
View user's profile Send private message
Barry
A BUNCH OF SPASTIC


Joined: 07 Nov 2018
Posts: 727

PostPosted: Wed Mar 13, 2019 11:39 pm    Post subject: Reply with quote

Or Tumosan
Back to top
View user's profile Send private message
5ivegearsinreverse
ROBERT JEKYLL & GORDON HYDE


Joined: 07 Nov 2018
Posts: 499
Location: Soke of Retardnumberplateshire

PostPosted: Thu Mar 14, 2019 12:09 am    Post subject: Reply with quote

Barry wrote:
Or Tumosan


Are they FIRM-related? I reckon there must be some Bathgate via Izmir heritage in there.
Back to top
View user's profile Send private message
Giles
DOING IT AGAIN FOR FUN AND PROFIT


Joined: 07 Nov 2018
Posts: 331

PostPosted: Thu Mar 14, 2019 9:13 am    Post subject: Reply with quote

Lord Sward wrote:
Blipper?


Steering wheel clock spring connector. For airbag cars.
Back to top
View user's profile Send private message
Giles
DOING IT AGAIN FOR FUN AND PROFIT


Joined: 07 Nov 2018
Posts: 331

PostPosted: Thu Mar 14, 2019 9:14 am    Post subject: Reply with quote

Barry wrote:
5ivegearsinreverse wrote:
Barry wrote:
Can't you just buy an Avensis and get on with life.


Or a Fendt or Laverda.

Oh hold on. AGCO shite...

A Fendt is too good for him, he'd be better of with a 20 year old Landini.


AGCO Shite. ARGO Shite.

I'm quite taken with the new Kubota tractors. Frog built with Japies engineering.
Back to top
View user's profile Send private message
Giles
DOING IT AGAIN FOR FUN AND PROFIT


Joined: 07 Nov 2018
Posts: 331

PostPosted: Tue May 21, 2019 8:21 am    Post subject: Reply with quote

I made the mistake of washing it last weekend.

It has repaid my kindness by shitting out the clutch slave cylinder seals and the driver's door fascia coming adrift.

WPC?
Back to top
View user's profile Send private message
Seamaster
A HEATHEN, CONCEIVABLY


Joined: 11 Nov 2018
Posts: 1337
Location: Summerisle

PostPosted: Tue May 21, 2019 8:32 am    Post subject: Reply with quote

Scrap the fucker and buy a Prius, that's my advice.
Back to top
View user's profile Send private message
GordonBennett
Modern Gentleman


Joined: 07 Nov 2018
Posts: 150

PostPosted: Tue May 21, 2019 9:11 am    Post subject: Reply with quote

I feel your pain Giles. I need to MOT the 220 Coupe imminently which is always a nerve wracking experience.
Back to top
View user's profile Send private message
Seamaster
A HEATHEN, CONCEIVABLY


Joined: 11 Nov 2018
Posts: 1337
Location: Summerisle

PostPosted: Tue May 21, 2019 9:36 am    Post subject: Reply with quote

What's the fucking matter with you cunts and your ASSORTED WRECKAGE?
Back to top
View user's profile Send private message
austin-towers
PLASTIC WELSH SPASTIC


Joined: 07 Nov 2018
Posts: 607

PostPosted: Tue May 21, 2019 9:52 am    Post subject: Reply with quote

Seamaster, I often wonder why you are here. Then I remember, it's because NO FUCKER ELSE WANTS THE JOB.
Back to top
View user's profile Send private message
marinast
IDEOLOGICAL RADONS


Joined: 07 Nov 2018
Posts: 601

PostPosted: Tue May 21, 2019 9:53 am    Post subject: Reply with quote

It's part of his CARE IN THE COMMUNITY PACKAGE.
Back to top
View user's profile Send private message
Lord Sward
SWARDUS ET PKLESS


Joined: 08 Nov 2018
Posts: 839

PostPosted: Tue May 21, 2019 4:29 pm    Post subject: Reply with quote

Giles wrote:
I made the mistake of washing it last weekend.

It has repaid my kindness by shitting out the clutch slave cylinder seals and the driver's door fascia coming adrift.

WPC?


The slave cylinder is no problem on them; unlike 75
Back to top
View user's profile Send private message
Barry
A BUNCH OF SPASTIC


Joined: 07 Nov 2018
Posts: 727

PostPosted: Tue May 21, 2019 7:48 pm    Post subject: Reply with quote

austin-towers wrote:
Seamaster, I often wonder why you are here. Then I remember, it's because NO FUCKER ELSE WANTS THE JOB.

Well YOU weren't exactly a GREAT REPLACEMENT
Back to top
View user's profile Send private message
austin-towers
PLASTIC WELSH SPASTIC


Joined: 07 Nov 2018
Posts: 607

PostPosted: Tue May 21, 2019 7:53 pm    Post subject: Reply with quote

PUT A SOCK IN IT ya POT BELLIED PADDY CUNT.
Back to top
View user's profile Send private message
MarkM
GLORIFIED ARTHUR DALEY


Joined: 07 Nov 2018
Posts: 430

PostPosted: Tue May 21, 2019 8:12 pm    Post subject: Reply with quote

He’s got a fucking point though hasn’t he? You sackless ginger cunt.
Back to top
View user's profile Send private message
Seamaster
A HEATHEN, CONCEIVABLY


Joined: 11 Nov 2018
Posts: 1337
Location: Summerisle

PostPosted: Tue May 21, 2019 8:31 pm    Post subject: Reply with quote

He ought to be CAGED.
Back to top
View user's profile Send private message
austin-towers
PLASTIC WELSH SPASTIC


Joined: 07 Nov 2018
Posts: 607

PostPosted: Tue May 21, 2019 8:40 pm    Post subject: Reply with quote

You just shut your fucking cake hole and do your job.
Back to top
View user's profile Send private message
Seamaster
A HEATHEN, CONCEIVABLY


Joined: 11 Nov 2018
Posts: 1337
Location: Summerisle

PostPosted: Tue May 21, 2019 8:49 pm    Post subject: Reply with quote

If it was up to me the fucker would be SHUTTERED without further ado.
Back to top
View user's profile Send private message
Barry
A BUNCH OF SPASTIC


Joined: 07 Nov 2018
Posts: 727

PostPosted: Tue May 21, 2019 8:58 pm    Post subject: Reply with quote

Seamaster wrote:
If it was up to me the fucker would be SHUTTERED without further ado.

Towers managed to do it. YOU'RE WORSE THAN THAT SPASTIC
Back to top
View user's profile Send private message
Ottertronic
THE RUSSIANS!!


Joined: 09 Nov 2018
Posts: 622

PostPosted: Tue May 21, 2019 9:01 pm    Post subject: Reply with quote

Give over Seaspacker, you've got a lazy lob-on over your forum "power" and you'd pap your crackers if it was being taken away. Classic moderator behaviour.
Back to top
View user's profile Send private message
620bob
HORMONAL REMAINIAC


Joined: 08 Nov 2018
Posts: 1126
Location: Bobniston

PostPosted: Tue May 21, 2019 9:01 pm    Post subject: Reply with quote

This won't end well
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Home of the official* MG3, MG6, MG GS & MG ZS forum Forum Index -> Readers’ drives All times are GMT + 1 Hour
Goto page Previous  1, 2, 3  Next
Page 2 of 3

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by K Seal © 2018 MacDroitwich Fisheries